18-7.020 Property Development Standards.
The property development standards for the MUX Zone are as follows:
a. Maximum Density. Except when the underlying General Plan Land Use Designation for the property is less (such as Medium Density Residential, which is a maximum of fifteen (15) units per acre), the twenty-five (25) density units per acre, including dwelling units, such as single occupancy units, in hotels and motels, but not including other hotel or motel units (also see Section 18-20.020).
b. Yards. See Section 18-20.040.
c. Maximum height: thirty-five (35') feet (also see Section 18-20.060). Additional building height up to sixty-five (65') feet may be approved as provided under CGC and CD below.
1. Performance Standards for Buildings Taller than Thirty-Five (35') Feet (All Required).
(a) The project shall include housing at a minimum residential density unit value of twelve (12) units per acre.
(b) For projects on sloping sites, the height limit on the downhill portion of the site shall be defined by a line seventy-five (75') feet above the average between the highest and lowest points of the site grade prior to development and seventy-five (75') feet above the lowest point.
(c) No more than fifty (50%) percent of the site area at the property frontage may be used for private parking facilities.
(d) The maximum height may be increased by ten (10') feet above the maximum allowed height when residential uses are provided above the ground floor except for properties abutting a residentially designated district. The building height increase for residential uses applies only if the top floor is residential and does not apply to buildings that have variance approval to exceed the permitted height.
d. Maximum coverage: eighty (80%) percent.
e. Minimum lot area: three thousand (3,000) square feet.
f. Parking. See Section 18-20.090. (Ord. #248-2020, S2 (Exh. A))